| Hey all! I challenge all of you to try and identify the following parts. My dream has always been to do a 5-speed swap on my Z (as well as a TT swap in a few years), and it is slowly becoming a reality. I finally picked up a 1990 5-speed NA tranny with 114k KM (~71k miles) on it, as well as an unknown performance clutch. Do any of you know what clutch this is? Is it any good or one of those cheap clutches from E-Bay? Part #1 - Performance Clutch: 
The letters "DK" are engraved on the clutch:
 
I had to remove my SSR Super NG-T rear wheels because one of them is slightly bent. Montreal is also pothole infested, and so far, 5 people on the street have told me that when they were driving in back of my Z, my wheel was "shaking" whenever I went over a pothole. I can also feel the car sway back and fourth when I go over a bump at higher speeds, so it is pretty dangerous. Additionally, my brembo rotor on the bent wheel is going through some crazy uneven wear, which I'm guessing is due to the fact that my wheel isn't balanced properly so I'd like to get that fixed ASAP. I will be replacing the rears temporarily with these unknown JDM wheels. Part #2 - JDM Wheels: 
Nothing is written on the back of these wheels so I have no clue who manufactured them. However, on each rivet is printed the name "Arrow". 
Finally, it's weird, but whenever I do an ECU diagnotics check, half of the time I get a code 34, and the other half of the time I get a code 55. Could this be why / what is this connector? It is not connected to anything in the back of my engine bay. Part #3 - Unknown connector: 
Thanks so much for all the help. I'll be sure to post some pics of my Z when she's worthy of a photoshoot!
|
Z Gurus, How well do you know the Z? [Identifying Parts] - 
